Advertisement
Available languages
Available languages
Always work with concentration. Always work in a carefully
considered way and do not use the tool if you are lacking
consideration.
During manual operation, work with a special circumspection
when dry drilling with dimensions between 100 and 200 mm !
For further safety instructions, see the enclosure.
The EHD 1801 is designed according to protective class II.
Prior to putting the tool into operation, check the mains voltage for
conformity with the requirements of the tool's nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
Additional Handle
For manual drilling, the EHD 1801 may be used only together with its
additional handle which comes with the tools. Place it on the gearing collar
from the front and fix it by counterclockwise rotation.
Switching ON and OFF
Short-time operation
ON:
Press the ON/OFF switch
OFF:
Release the ON/OFF switch
Long-time operation
ON:
Keeping the ON/Of switch pressed, push in the arrestor button.
OFF:
Press and release the ON/OFF switch again.
Electrical Connection
Cross section in sq. mm
1.5
20 m
50 m
15
2.5
40 m
80 m
Advertisement
