Security Seal Installation; Pressure Sensitive Security Seal - Honeywell MS2420 Installation And User Manual

Security Seal Installation

Note: The certification of the weighing mechanism of the scale version of this scanner is subject to federal,
state and local Weights and Measures statutes and regulations and can only be performed by
authorized government agencies and/or their duly registered agents. Each time the scale or weighing
mechanism is calibrated, it should be properly sealed with a paper seal or a wire seal prior to being
placed into service in commerce.
It is the responsibility of the owner of the scale to confirm compliance with the relevant Weights and
Measures statutes and regulations applicable in your area by checking with the appropriate government
agency before placing a newly calibrated unit into service or removing any official seals.
Type of seal to be used will depend on the guidelines specified by the local Weights and Measures
authorities.
The security seal must only be installed if there were no errors during the scale calibration verification tests.

Pressure Sensitive Security Seal*

1. Temporarily remove the platter and place it in a safe location.
2. Apply the adhesive calibration security seal over the calibration
button access hole (see Figure 56).
3. With very light pressure, push down on the adhesive calibration
security seal label to ensure a firm adhesion is created
(see Figure 57).
4. Reinstall the platter.
* These procedures are for MS2420/MS2430 Scanner/Diva Scale models only.
60
Figure 58. Platter Installation
Figure 56.
Figure 57.