Ventilation; Starting-Up And Appliance Management; Before The First Use; Induction Principle - Caple C875I Instruction Manual

Ventilation

The cooling system is fully automatic. The cooling fan starts with a low speed when the heat
brought out by the electronic system reach a certain level. The ventilation starts at high speed when
the hob is intensively used. The cooling fan reduces speed and stops automatically when the
electronic circuit is cooled sufficiently.

Starting-up and appliance management

Before the first use

Clean your hob with a damp cloth, and then dry the surface thoroughly. Do not use detergent which
risks causing blue-tinted colour on the glass surface.

Induction principle

An induction coil is located under each heating zone. When it is engaged, it produces a variable
electromagnetic field which produces inductive currents in the ferromagnetic bottom plate of the
pan. The result is a heating-up of the pan located on the heating zone.
Of course the pan has to be correct:
 All ferromagnetic pans are recommended (please check it with a small magnet): cast iron and
steel pans, enamelled pans, stainless-steel pans with ferromagnetic bottoms.

The following are excluded: cupper, pure stainless-steel, aluminium, glass, wood, ceramic,
stoneware.
The induction heating zone adapts automatically to the size of the pan. A pan with a very small
diameter may not work (less than 10cm). This pan diameter varies the function of the heating zone
diameter.
If the pan is not correct for induction hob cooking the display will show [ U ]. You will need to use
an alternative pan.

Touch controls

Your induction hob is equipped with electronic controls with sensitive touch keys. When your finger
presses the key, the corresponding command is activated. This activation is validated by a control
light, a letter or a number in the display and/or a "beep" sound. In the case of a general use press
only one key at the same time.
Power selection "Slider" and timer settings
To select the power with the slider, slide your finger on the "Slider" zone. You can also have direct
access to the desired power level by placing your finger directly on the chosen level.
Power selection zone "SLIDER" and
timer setting zone
"SLIDER
7
Direct