MTU 12V 4000 L32 F Operating Instructions Manual page 165

3. Remove locknut (1).
4. Remove filter cover (3) with washer (2).
5. Carefully lift out fine filter (6).
6. Carefully lift out coalescer filter (5).
7. Clean sealing faces and inside of housing.
8. Check condition of gaskets on new fine filter
and new coalescer filter.
Note: The fine filter (6) must be installed in the cor-
rect position in the housing.
9. Place fine filter (6) in housing, ensuring it is
straight.
Note: The coalescer filter (5) must be installed in
the correct position in the housing.
10. Place coalescer filter (5) in housing, ensuring
it is straight.
11. Fit filter cover (3), ensuring it is positioned
correctly.
12. Screw on washer (2) with new locknut (1) and use torque wrench to tighten to specified tightening torque.
Name
Locknut
13. Fit housing cover (1).
14. Fit clamp (2) neatly and use torque wrench to tighten to specified tightening torque.
Name
Clamp
Size Type
Tightening torque
Size Type
Tightening torque
MS150104/02E 2016-11 | Crankcase Breather | 165
Lubricant Value/Standard
8 Nm
Lubricant Value/Standard
5 Nm