Starting And Quitting; Starting The Vivid 9I - Konica Minolta VIVID 9i/VI Instruction Manual

Starting and Quitting

Starting the VIVID 9i

[Operating Procedure]
1
Set the power switch to ON (" ").
Power will be supplied to the VIVID 9i and initial set-
up is performed. After several dozen seconds,
"PLEASE OPEN LASER BARRIER AND PRESS
ANY KEY" will be displayed on the viewfinder.
N
ote
When turning power ON again after it has been turned
OFF, wait at least 5 seconds before doing so. Failure to ob-
serve this may result in malfunction or breakdown of the
VIVID 9i.
M
emo
To ensure precise measurement, allow the unit to warm up
for at least 10 minutes.
2
Remove the lens cap from the receiving lens.
3
Remove the laser barrier.
POWER
SCSI
AC IN
21