Table of Contents
Advertisement
16
AIR FILTER
Tools required:
25-50 mm (1 or 2 in.) medium bristle paint brush.
Parts required:
90030 REPOWER
1.
Close choke (Cold Start Position). This prevents dirt from entering
the carburetor throat when the air filter is removed. Brush accumu-
lated dirt from the air cleaner area.
2.
Remove the air cleaner cover. Clean and inspect the air filter for
damage. If air filter is fuel soaked or very dirty, replace.
3.
If air filter can be cleaned and reused, be certain it:
•still fits the cavity in the air cleaner cover.
•is installed with the original side out.
NOTE
Carburetor adjustment may be needed after air filter cleaning or
replacement.
FUEL FILTER
Level 1.
Tools required:
Fuel line hook, 200-250 mm (8-10 in.) length of wire
with one end bent into a hook. Clean rag, funnel, and
an approved fuel container.
Parts required:
90030 REPOWER AIR & FUEL FILTER KIT
WARNING
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling.
1.
Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2.
Use the "fuel line hook" to pull the fuel line and filter from the tank.
3.
Remove the filter from the line and install the new filter.
TM
AIR & FUEL FILTER KIT.
DANGER
Advertisement
Table of Contents
