Verifying The Hardware Installation; Starting Nas Configuration - Cisco NSS32 Administration Manual

Getting Started

Verifying the Hardware Installation

STEP 4
STEP 5
Verifying the Hardware Installation
NOTE

Starting NAS Configuration

Cisco Small Business NSS300 Series Smart Storage Administration Guide
Plug the other end of the power cord into a battery-backed-up outlet on the UPS,
or a standard power outlet if a UPS is not being used.
To start the NAS, press and release the Power button on the front panel.
Listen for one beep. Wait for one to two minutes until the device beeps another
time.
The device has started successfully. The power light turns solid green when the
NAS is ready to use.
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the LED states, as described in
Series Smart Storage, page
If you encounter problems, consider the following tips:
• If the NAS does not recognize the disk drives, possible causes and
solutions are:
- Confirm the disk drive is supported by Cisco. See the Cisco approved
vendor list at www.cisco.com/go/smallbizsmartstorage.
- Disk tray is installed incorrectly. Try removing and reseating the disk tray.
- Power the device off, then back on to recognize the disk drives.
If you need help resolving a problem, visit the Cisco Small Business Support
Community at www.cisco.com/go/smallbizsupport. For technical documentation
and other links, see Where to Go From Here, page
Before you begin the system configuration, make sure that you have a computer
that meets the following requirements:
Getting to Know the NSS300
12.
264.
2
24