Managing the System
Disk Management
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
Cisco Small Business NSS300 Series Smart Storage Administration Guide
To run the iSCSI Quick Configuration Wizard and configure the iSCSI target
service on the NAS:
Choose Disk Management > iSCSI from the Navigation menu. The Portal
Management window opens.
Click Enable iSCSI Target Service and enter an iSCSI Service Port number. The
default service port is 3260.
Optionally, click Enable iSNS to enable Internet Storage Name Service (iSNS) and
enter the iSNS Server IP address.
Click Apply to save the settings.
Click the Target Management tab to create iSCSI targets on the NAS. If you have
not created any iSCSI targets, the Quick Configuration Wizard appears.
Click OK to launch the wizard.
From the iSCSI Quick Configuration Wizard window options, click iSCSI Target
with a mapped LUN, then click Next.
Click Next again and the wizard will guide you through:
•
Creating an iSCSI target
•
Creating an iSCSI LUN and mapping it to the target
From the Create New iSCSI Target window, enter the following parameters:
3
120