Setting; Camera - Panasonic CJ-HDR216 User Manual

4.10 Setting

4.10.1 Camera

4.10.1.1 Image
For analog channel, the camera interface is shown as in Figure ‎ 4 -50.
Channel: Select a channel from the dropdown list.

Saturation: It is to adjust monitor window saturation. The value ranges from 0 to 100.
The default value is 50. The larger the number, the strong the color is. This value has
no effect on the general brightness of the whole video. The video color may become
too strong if the value is too high. For the grey part of the video, the distortion may
occur if the white balance is not accurate.
attractive if the value is too low. The recommended value ranges from 40 to 60.

Brightness: It is to adjust monitor window bright. The value ranges from 0 to 100. The
default value is 50. The larger the number is, the bright the video is. When you input
the value here, the bright section and the dark section of the video will be adjusted
accordingly. You can use this function when the whole video is too dark or too bright.
Please note the video may become hazy if the value is too high. The recommended
value ranges from 40 to 60.

Contrast: It is to adjust monitor window contrast. The value ranges from 0 to 100. The
default value is 50. The larger the number is, the higher the contrast is. You can use
this function when the whole video bright is OK but the contrast is not proper. Please
note the video may become hazy if the value is too low. If this value is too high, the
dark section may lack brightness while the bright section may over exposure .The
recommended value ranges from 40 to 60.

Chroma: It is to adjust monitor video brightness and darkness level. The default value
is 50. The bigger the value is, the large the contrast between the bright and dark
section is and vice versa.

Sharpness: The value here is to adjust the edge of the video. The value ranges from 0
to 100. The larger the value is, the clear the edge is and vice versa. Please note there
is noise if the value here is too high. The default value is 50 and the recommended
value ranges from 40 to 60.

Image enhance: It is to enhance video quality. The larger the value is, the clearer the
video is. But the noise may become large too.

2D NR: It is to process the noise of the single image. The video may become soft after
process. The larger the value is, the better the effect is.

3D Denoise: It is to process the multiple-frame (at least two frames). It is to use the
frame information between the following two frames to reduce noise. The larger the
value is, the better the effect is.
Please note the video may not be
63