Table of Contents
Advertisement
6.3.4. FLK (FLICKERLESS)
Select this when you experience picture flicker, this happens when
there is a clash with the installed lighting frequency.
ON: Hold shutter speed (NTSC: 1/100)
6.3.5. AGC (Auto Gain Control)
It is possible to adjust it within 0 ~ 20 using the LEFT or RIGHT button.
When the Low illumination: The higher the gain level, the brighter
the picture but the higher the noise.
6.3.6. INTENSIFY
It is possible to adjust with in OFF, X2, X4, X8, X16, X32, X64, X128,
X256, X512 using the LEFT or RIGHT button. When low light is used
to increase the sensitivity.
6. 4.
WHITE BAL. – White Balance Setup
– Select WHITE BAL. using the UP and DOWN buttons and then
press MENU to enter the exposure setup.
– You can setup ATW, PUSH and MANUAL.
– Select desired submenu using the UP and DOWN buttons and
use LEFT and RIGHT buttons to set the option.
6.4.1. ATW
When the Color temperature is automatically adjusted to 2,000°K to 11,000°K.
6.4.2. PUSH
If the set color temperature doesn't meet the image.
Press the MENU button to fix color temperature to specific image.
If the environment changes, readjust it.
6.4.3. MANUAL
To set a certain color temperature with RED, BLUE.
Select MANUAL using the LEFT or RIGHT button and press the MEUN
button then W.B. MANUAL is activated.
RED
To adjust density of RED. (0 ~ 20)
BLUE
To adjust density of BLUE. (0 ~ 20)
Operating Camera
MANUAL
RED
9
BLUE
15
RETURN
15
Advertisement
Table of Contents
