Parrot Sequoia User Manual page 8

Home
The Home screen is used to set up Sequoia.
Setting up the capture mode
Select the capture mode you want:
• Single: take one shot at a time.
• Time-lapse: take burst shots at regular intervals. Specify, in the "time-
lapse" field, the interval of time (in seconds) between each shot.
• GPS: take burst shots at regular distances. Specify, in the "GPS" field,
the distance in metres between each photo.
Once the set up is complete, press the Shot button. The camera starts
taking shots. To stop taking shots, press the Stop shot button.
Setting up the sensors
Select:
• Image resolution: 0.3 Mpx or 1.2 Mpx.
• Bit depth: 8-bit or 10-bit.
• The sensors that you want to enable during the flight (Green, Red, Red
Edge, Near Infrared and RGB). To do this, click on the sensors that you
want to enable or disable.
10
Status
GPS
Parrot Sequoia Home
GPS
Number of satellites: 7
Precision: 1m
Speed: 10m/s
Altitude: 35m
Instruments
Sunshine sensor
Temperature
The GPS screen tells you about:
• The number of satellites detected.
• Sequoia's precise GPS /GNSS position in metres.
• Sequoia's travel speed in meters per second.
• Sequoia's altitude in meters.
Instruments
Parrot Sequoia Home
GPS
Instruments
Body
ROLL PITCH YAW
-26° 21° 22°NE
Sunshine sensor
Temperature
The Instruments screen tells you about the orientation of the multispectral
sensor and the sunshine sensor.
Status Gallery
Status Gallery
Sunshine sensor
ROLL PITCH YAW
2° -3° 22°NE
11