Network Setup; Hotspot Mode - Delta NovoPRO User Manual

2. Network Setup

Depending on where your presentation content is located and the number of participants in the
presentation, you may select one of the following connection modes from the NovoPRO home
screen.
A) Client Mode – for when your content is residing in a private cloud or the Internet cloud, and
the number of participants is more than eight
B) Hotspot Mode – for when your content is residing on your PC or tablet, and the number of
participants is eight or fewer
C) Neither – for when your content is stored on your microSD card
The NovoPRO defaults to start up in Wi-Fi Hotspot mode, which is the most direct way to create a
wireless presentation without using a Wi-Fi access point (AP) or connecting to a wired network. If
this is your preferred mode, go to section 2.1 "Hotspot Mode" for steps on making a presentation.
If you would prefer to make your presentation through an existing network (either wireless or
wired), please refer to section 2.2 "Client Mode" in this chapter.

2.1 Hotspot mode

Right out of the box, NovoPRO's Wi-Fi is set to function as a Wi-Fi Hotspot and will stay in this
configuration until you alter it. The default SSID for the Wi-Fi hotspot is "NVC_XXXXX", where
"XXXXX" is a device-generated string of characters and numbers. A USB mouse is required for the
following steps.
If you alter your settings and then choose to revert to Hotspot Mode, on the NovoPRO home
screen, select WiFi-> Hotspot Mode->Apply.
For a PC to connect to the NovoPRO Hotspot, click the network icon
SSID of the NovoPRO device shown on the home screen (for example, NVC_DC9AB) and click
Connect.
For a Mac to connect to the NovoPRO hotspot, click the network icon
NovoPRO device shown on the home screen (for example, NVC_DC9AB) and click Join. Ignore any
security warnings.
Copyright © 2015 DELTA Electronics, Inc. All rights reserved.
on task bar. Select the
Select the SSID of the
.
Page 12