Before You Begin - Minolta FIERY Pi5500 Configuration Manual

1

1-11 Before you begin

Before you begin
The following steps should be completed before you configure the Pi5500 and the
workstations that will print to the Pi5500. A service technician will have performed
some initial installation.
T P 5500
O PREPARE FOR I
1. Print a copier test page to make sure the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the Pi5500.
3. To confirm this connection, turn on the copier and then the Pi5500 and print a Test
Page from the Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. (See "Pi5500 Control Panel" on page 2-3.) Choose Print Pages, and
then choose Test Page.
4. With both the copier and the Pi5500 turned off, connect the network cable to the
Pi5500, as described in the following section.
The network should already be installed and operational.
5. Turn on the copier and then the Pi5500.
6. Prepare network servers to share Pi5500 user software and to enable networked
users to print to the Pi5500, and proceed to Setup.
For details, see Chapters 2 and 3.
CONFIGURATION