Subaru FORESTER 2001 Quick Reference Index page 38

14) Remove adhesive overflowing from outside of
glass until it becomes level with outer height of
glass. Then, add adhesive to portions that need it,
and clean with alcohol or white gasoline.
15) First, press-fit upper front window molding and
last, roof molding.
CAUTION:
¼ When door is opened/closed after glass is
bonded, always lower door glass and then
open/close it carefully.
¼ Move vehicle slowly.
16) After completion of all work, allow vehicle to
stand for about 24 hours.
NOTE:
For minimum drying time and time the vehicle must
be left standing before driving after bonding, follow
instructions or instruction manual from the adhe-
sive manufacturer.
17) After curing of adhesive, pour water on exter-
nal surface of vehicle to check that there are no
water leaks.
CAUTION:
When a vehicle is returned to the user, tell him
or her that the vehicle should not be subjected
to heavy impact for at least three days.
18) Install cowl panel.
INSTALLATION, Cowl Panel.>
WINDSHIELD GLASS
G5M0496
G5M0417
<Ref. to EI-25,
GW-37
Glass/Windows/Mirrors