Subaru FORESTER 2001 Quick Reference Index page 30

C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting bolts
of stabilizer, upper stopper, and sash are loose and
door glass is raised so that it is in contact with
weatherstrip.
1) Temporarily tighten one adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten regulator B-channel in a
position slightly lower than midpoint of slotted hole.
3) Lower door glass 10 to 15 mm (0.39 to 0.59 in)
from fully closed position. While applying outward
pressure of 45.0±4.9 N (4.59±0.50 kgf, 10.12±1.10
lb) (F) to upper edge of glass above midpoint of
two outer stabilizers, press inner stabilizer until it
just touches the glass, then secure it.
4) For adjustment of clearance between front and
rear glasses, loosen nuts (A), and move glass sash
back and forward until clearance becomes the
value shown.
FRONT DOOR GLASS
S905452A01
G5M0421
S5M0199B
S5M0198A
5) For adjustment of upper and lower ends of cen-
ter pillar, loosen adjusting nut (A).
6) Adjust so that upper and lower ends of center
pillar are the same size.
7) For glass stroke adjustment, close door, raise
glass until positional relationship between glass
and weatherstrip becomes as shown. And secure
the glass so that upper stopper lightly touches the
glass holder.
GW-29
Glass/Windows/Mirrors
S5M0197B
G5M0639
S5M0200A