Subaru FORESTER 2001 Quick Reference Index page 31

Glass/Windows/Mirrors
8) After stabilizer adjustment, carry out glass
crimp adjustment. First, visually ensure positional
relationship between retainer & molding and glass
of the roof side, and then begin with rear sash
adjustment. Adjust two adjusting bolts alternately
step by step to obtain dimensions shown below
(cross-section A).
NOTE:
If two nuts are loosened at the same time, sash
moves back and forth. Therefore, when one nut is
adjusted, secure the other.
9) Make the same adjustment of two adjusting
bolts of rear sash.
CAUTION:
Do not tilt sash bracket to inner panel during
adjustment. Otherwise
operation cannot be achieved.
10) Make adjustment of front sash in the same
manner as that of rear sash.
CAUTION:
Although front and rear sashes must, as a rule,
be adjusted in the same manner, in some door
installation, the adjustment in a different man-
ner may be required. However, adjustment of
one sash to the maximum amount and the
other to the minimum amount is not permitted.
Such adjustment may result in application of
excessive load to regulator.
FRONT DOOR GLASS
S5M0200A
smooth regulator
S5M0201A
GW-30
11) After adjustments, tighten nuts.
12) After adjustment of glass, if there is a gap
between outer lip of gusset and glass surface,
adjust the gap with adjusting bolt (A) in lower fitting
part of gusset to prevent generation of wind noise.
13) During adjustments, loosen other three clamp-
ing bolts.
14) After adjustment, tighten bolts and nuts.
S5M0513A