10/100/1000Base-T Autosensing Ethernet Port Led; 100/1000Base-X Sfp Port Led - H3C S5560-EI series Installation Manual

10/100/1000BASE-T autosensing Ethernet port LED

The switch provides a status LED for each 10/100/1000BASE-T autosensing Ethernet port. The port LED
and the MODE LED work in conjunction to indicate the operating status of the 10/100/1000BASE-T
autosensing Ethernet port.
Table 33 10/100/1000BASE-T autosensing Ethernet port LED description
MODE LED status
Steady green (rate mode)
Flashing green (1 Hz) (PoE
mode, available only for
S5560-30C-PWR-EI and
S5560-54C-PWR-EI
switches)
Flashing yellow (IRF mode)

100/1000Base-X SFP port LED

On the S5560-30F-EI and S5560-34C-EI switches, the SFP port LED and the MODE LED work in
conjunction to indicate the operating status of the SFP port.
Table 34 100/1000Base-X SFP port LED description
MODE LED status
Steady green (rate
mode)
10/100/1000BASE-T
autosensing Ethernet
port LED status
Steady green
Flashing green
Steady yellow
Flashing yellow
Flashing yellow (3 Hz)
Off
Steady green
Flashing green (3 Hz)
Steady yellow
Flashing yellow (3 Hz)
Off
Steady green
SFP port LED status Description
A link is present on the port and the port is operating at 1000
Steady green
Mbps.
Flashing green The port is sending or receiving data at 1000 Mbps.
A link is present on the port and the port is operating at 100
Steady yellow
Mbps.
Description
A link is present on the port and the port is operating
at 1000 Mbps.
The port is sending or receiving data at 1000 Mbps
The port is operating at 10/100 Mbps.
The port is sending or receiving data at 10/100
Mbps
The port has failed POST.
No link is present on the port.
PoE power supply is normal.
The device attached to the port requires power
higher than the maximum or currently available PoE
output power on the port.
The port is experiencing a PoE failure.
The port has failed POST.
The port is not supplying power through PoE.
The port status LEDs on the switch work in
conjunction to indicate the IRF member ID of the
switch. For example, if the LEDs for ports 1 to 5 are
steady green and the other port LEDs are off, the IRF
member ID of the switch is 5.
85