Snorkel TB60 Operator's Manual page 75

Chapter 11 – Troubleshooting
Fuel Line Air Bleeding – Kubota V2403-M-T
If the engine will not start because of air in the fuel line,
use one of the following methods to remove the air to
restart the engine.
Open Bleeder Valve and Crank Engine
Slightly open the bleeder valve (refer to Figure 11.1)
and crank the engine for a few seconds to let the air
out. Close the valve and start the engine.
Bleeder Valve
Fuel Filter
Fuel Line
Bleeder Pump
Figure 11.1 – Kubota V2403-M-T
Fill the Fuel Filter
Remove the fuel filter. Fill the filter with fuel of the cor-
rect grade and replace it. Crank the engine for a few
seconds to start the engine.
Operate Bleeder Pump
Slightly open the bleeder valve and operate the bleeder
pump up and down until the air is out of the line. This
make take several minutes of operating the pump before
the air is removed from the line. Close the valve and
start the engine.
TB60 – 0083739 71