Table of Contents
Advertisement
2. Add opvxa24xx in /usr/src/zaptel-xx/zaptel.sysconfig
#MODULES="$MODULES ztdummy" # Zaptel Timing Only Interface
MODULES="$MODULES xpp_usb"
MODULES="$MODULES opvxa24xx" # OpenVox A2410P - Modular FXS/FXO interface (1-24 ports)
3. Add opvxa24xx in /usr/src/zaptel-xx/kernel/xpp/utils/genzaptelconf
# The rest of the lines are per-channel lines
sed -e 1,2d $procfile | \
while read line
do
# in case this is a real channel.
chan_num=`echo $line |awk '{print $1}'`
case "$line" in
*WCTDM/* | *\ WRTDM/* | *OPVXA1200/*
# TDM400P/2400P and similar cards (Sangoma A200, OpenVox A1200)
# this can be either FXS or FXO
3.3 Installation
Before installing zaptel and asterisk, please make sure that some supporting
packages have been installed.
Note that if there is no kernel source in the system, user should install them.
User can run yum again:
It is time to check for the availability of some supporting packages:
rpm -q bison
rpm -q bison-devel
rpm -q ncurses
rpm -q ncurses-devel
rpm -q zlib
rpm -q zlib-devel
rpm -q openssl
rpm -q openssl-devel
rpm -q gnutls-devel
rpm -q gcc
// confirm GCC-4.0 above
rpm -q gcc-c++
If any of those packages are not installed, please install them by using yum
yum install bison
yum install bison-devel
OpenVox Communication Co. Limited.
# Xorcom Astribank Device
Figure 6: zaptel.sysconfig
|
*OPVXA24XX/*)
Figure 7: genzaptelconf
yum install kernel-devel
User Manual
.
URL:
www.openvox.cn
9
Advertisement
Table of Contents
