Table of Contents
Advertisement
3.4 Configure
1. Loading modules for opvxa24xx:
modprobe zaptel
modprobe opvxa24xx opermode=YOUR COUNTRY
genzaptelconf
ztcfg –vvvv
Then run dmesg
If user uses AE2410P, from figure 9, user can find EC module has been detected.
OpenVox A2410P version: 1.0
Module 0: Installed -- AUTO FXO (FCC mode)
Module 1: Installed -- AUTO FXO (FCC mode)
Module 2: Installed -- AUTO FXO (FCC mode)
Module 3: Installed -- AUTO FXO (FCC mode)
Module 4: Installed -- AUTO FXS/DPO
Module 5: Installed -- AUTO FXS/DPO
Module 6: Installed -- AUTO FXS/DPO
Module 7: Installed -- AUTO FXS/DPO
Module 8: Installed -- AUTO FXO (FCC mode)
Module 9: Installed -- AUTO FXO (FCC mode)
Module 10: Installed -- AUTO FXO (FCC mode)
Module 11: Installed -- AUTO FXO (FCC mode)
Module 12: Installed -- AUTO FXS/DPO
Module 13: Installed -- AUTO FXS/DPO
Module 14: Installed -- AUTO FXS/DPO
Module 15: Installed -- AUTO FXS/DPO
Module 16: Installed -- AUTO FXO (FCC mode)
Module 17: Installed -- AUTO FXO (FCC mode)
Module 18: Installed -- AUTO FXO (FCC mode)
Module 19: Installed -- AUTO FXO (FCC mode)
Module 20: Installed -- AUTO FXS/DPO
Module 21: Installed -- AUTO FXS/DPO
Module 22: Installed -- AUTO FXS/DPO
Module 23: Installed -- AUTO FXS/DPO
Openvox VPM: echo cancellation supports 32 channels
Openvox VPM: echo cancellation for 32 channels
Openvox VPM: hardware DTMF disabled.
Openvox VPM: Present and operational servicing 1 span(s)
2. Checking the configure files
The command genzaptelconf will automatically generate the zaptel.conf under /etc
and zapata-channels.conf under /etc/asterisk. Please check the setting of
zaptel.conf, it looks like the following:
OpenVox Communication Co. Limited.
Figure 9: EC detection
User Manual
URL:
www.openvox.cn
11
Advertisement
Table of Contents
