Operation - pro.point bd4600 User Manual

8436776

OPERATION

SETTING UP THE TILE SAW
1. Take out the rip guide and power supply cord from the bottom storage.
2. Detach the Blade guard, and then open the right cutting table to fill the reservoir with water
to the recommended level. Keep the water level with the basin lines.
3. Attach the blade guard above the blade and close the right cutting table. Now you are
ready to cut!
STEPS FOR RIP, ANGLE & MITRE CUTS
1. The edge of the cutting table (upper frame) is marked with rigid dimension in both
inches and centimeters for accurate cutting.
2. Align the tile with the proper guide. The cutting blade should be on the waste side of the
cutline to maintain the original measurement.
3. For 90° rip cuts, lean the material against the tile guide once it is in position, then push
the material forward to the blade.
4. For 0° to 45∘angle cuts, attach the mitre guide on the rip guide. Choose the degree you
want and tighten the adjustment knob. Then push the mitre guide and material together
forwards the blade to cut the material.
5. For bevel cuts raise the right cutting table to the desired angle, you can choose 22.5°, 30°,
and 45°. Put the two stands into the grooves to hold the cutting table in place. Place the
material face down onto the left cutting table and you are ready to cut.
OPERATION
CAUTION! Follow these steps before making the first cut:
• Check that the tile saw is unplugged from the power supply until ready to cut.
• Choose the correct cutting blade for the material to be cut. Check the specifications that come with the
cutting blade before selection.
• Always keep water level at the recommended level. Do not let the saw run dry!
1. Set the cutting blade depth to 1/8 in. beyond the material's thickness.
2. Turn the tool on and check that the cutting blade isn't wobbling and the water is contacting both sides of the
cutting blade.
3. Allow the cutting blade to achieve full speed before making the cut. Maintain a firm grip when the cutting blade
comes in contact with the workpiece to prevent kickback. Move the tile slowly in a straight line until the cut is
complete. Do not force the tile saw.
10
7 in. Portable Tile Saw
For technical questions call: 1-800-665-8685
V 2.0
1. - 3.
4.
5.