Default Approval Level - Hasselblad 503CW User Manual

1

2

3
4
DEFAULT APPR. LEVEL
The Instant Approval Architecture system helps you to evaluate and
mark each image based on how well it has come out. By default, the
system assigns an initial approval status for each new shot based
on an analysis of the distribution of exposure levels. In the factory
configuration, the status of each new shot is assigned as follows:
• Green (approved):
The new shot seems to have been exposed correctly.
• Yellow / Amber (unclassified):
The new shot seems to have been over- or under-exposed.
However, you might choose instead to override this system and have
all new shots assigned either as green or yellow, regardless of the
exposure analysis results. A typical strategy could be to assign all
shots to yellow and then review all of the shots later and promote
only the best ones to green status. At the same time you might
demote the most doubtful shots to red status.
See also Using Instant Approval Architecture for complete details
about working with the approval system.
To change the default status assigned to each new image:
1. Press the MENU button.
2. Press  to navigate down and select the Storage level.
Press  and then  to navigate down and select Default
Appr. level. Press  to open the Default Appr. level dialog.
3. Use the or button to step through the available set-
tings until the default status you wish to use (auto, green or
yellow) is shown.
4. Either move on to another setting by using the navigator but-
ton or press the menu (EXIT) button to exit the menu system
and keep your setting.
58