Troubleshooting - Hasselblad 503CW User Manual

Technical specifications continued — Digital capture unit / CFV
Color management
DAC digital lens correction
Color display
IR filter
ISO speed range
Longest shutter speed
Battery power
IAA - Instant Approval Architecture
. Histogram analysis
. Acoustic feed back
Computer support
Host connection
Operating temperature
Troubleshooting — 503CW
Hasselblad equipment is built to give long and trouble-free service, especially when you follow the maintenance and care advice at the end
of this manual. If however you encounter any operating difficulties because you are not familiar with the camera system, the following table
may help to resolve them. If the problem persists and the camera is still under guarantee, you should contact your Hasselblad dealer. If the
guarantee has expired, you should contact a Hasselblad Authorised Service Center for advice.
Problem
There is no image on the focusing
screen
You cannot remove the front
protective cover
You cannot attach the lens
You cannot remove the lens
Hasselblad RGB
. full dynamics
. reproduction dynamics
Support for DAC for Carl Zeiss lenses included in Phocus
TFT type, 2.5 inch
Mounted on CCD sensor
50, 100, 200, 400
32 seconds
SONY InfoLithium L, up to 8 hours of shooting capacity
Included, with:
yes
yes
Macintosh: OSX
PC: NT, 2000, XP
Firewire 800 (IEEE1394b)
0 – 45 deg. C / 32 – 113 deg F
Possible cause
• The camera is in the pre-released or
released position
• The lens cap is still in place
• The camera is in the pre-released or
released position
• The lens is in the released position
• The camera body is in the pre-released
or released position
• The camera body is in the pre-released
or released position
83
Remedy
• Complete the camera release and rewind
the camera
• Remove the lens cap
• Complete the camera release and rewind
the camera
• Wind the lens
• Complete the camera release and rewind
the camera
• Complete the camera release and rewind
the camera