Renault CLIO Driver's Handbook Manual page 228

BATTERY: troubleshooting
Starting the vehicle using the
battery from another vehicle
Proceed as follows when starting your
vehicle from another vehicle's battery:
Obtain suitable jump leads (large) from
an approved Dealer or, if you already
have jump leads, ensure that they are
in perfect condition.
The two batteries must have an iden-
tical nominal voltage of 12 volts. The
battery supplying the current should
have a capacity (amp-hours, Ah) which
is at least the same as that of the dis-
charged battery.
Ensure that there is no risk of contact
between the two vehicles (risk of short
circuiting when the positive terminals
are connected) and that the discharged
battery is properly connected. Switch
off your vehicle ignition.
Start the engine of the vehicle supply-
ing the current and run it at an interme-
diate engine speed.
5.30
(continued)
1
A
Attach the positive lead A to the (+) ter-
minal 1 of the discharged battery, then
to the (+) terminal 2 of the battery sup-
plying the current.
Attach the negative lead B to the (–)
terminal 3 of the battery supplying the
current, then to the (–) terminal 4 of the
discharged battery.
Check that there is no contact between
leads A and B and that the positive
lead A is not touching any metal parts
on the vehicle supplying the current.
Start the engine as you would normally.
4
As soon as it is running, disconnect
B leads A and B in the reverse order (4-
3-2-1).
3
2