Renault CLIO Driver's Handbook Manual page 206

TYRE INFLATION KIT
3
7
– adjust the pressure: to increase
it, continue inflation with the kit, to
reduce it, press button 7 located on
the inflation adapter.
If the correct pressure cannot be
achieved, repair is impossible. Do
not drive the vehicle. Consult an ap-
proved dealer.
Once the tyre is correctly inflated,
remove the kit: slowly unscrew the in-
flation adapter 6 to prevent any repair
product from escaping and screw the
hose to the bottle opening to prevent
the product from escaping.
5.8
(continued)
Affix the driving recommendation label
to the dashboard where it can easily be
seen by the driver;
Put the kit away.
Start driving immediately, and after 6
miles (10 kilometres) or 10 minutes of
driving, stop to check the tyre pressure.
If it is above 1.3 bar, adjust it to the rec-
ommended pressure (refer to the infor-
mation on "Tyre pressures"), otherwise
5
contact an approved dealer: repair is
not possible.
6
Please be aware that a
poorly tightened or miss-
ing valve cap can make the
tyres less airtight and may
lead to pressure loss.
Always use valve caps identical to
those fitted originally and tighten
them fully.
Precautions when using the
kit
The kit should not be operated for more
than 15 consecutive minutes.
Nothing should be placed
around the driver's feet
as such objects may slide
under the pedals during
sudden braking manoeuvres and
obstruct their use.
Following repair with the kit,
do not travel further than
120 miles (200 km). In addi-
tion, reduce your speed and
under no circumstances exceed
48 mph (80 km/h). The sticker, which
you must affix in a prominent posi-
tion on the dashboard, reminds you
of this.
Depending on the country or local
legislation, a tyre repaired with the
inflation kit will need to be replaced.