Indications On The Display Of The Accessory - WEG CFW100 Installation And Operation Manual

5 INDICATIONS ON THE DISPLAY OF
THE ACCESSORY
State
STANDBY
READY
COPY
PASTE
PAR
SPLC
COPY
ERROR
PASTE
ERROR
LOW
BATTERY
PARAM
COPY
ERROR
SOFTPLC
COPY
ERROR
HMI
Indicates that the accessory is
disconnected from the inverter.
Indicates that the system (inverter +
accessory) is ready to perform the
transfer or it has already done it.
The variable monitoring bar
indicates the battery level.
Indicates that the copy function
(CFW100 → CFW100-MMF) was
selected.
When the OK key is pressed,
the PAR and SPLC modes will
be accessed. If no errors occur,
the display will indicate the
READY state.
Indicates that the paste function
(CFW100-MMF → CFW100) was
selected.
When the OK key is pressed,
the PAR and SPLC modes will
be accessed. If no errors occur,
the display will indicate the
READY state.
It indicates the parameter tables
are being transferred. The variable
monitoring bar will indicate the
transfer process.
It indicates the SoftPLC application
is being transferred. The variable
monitoring bar will indicate the
transfer process.
Indicates that there was an error
in the copy
(CFW100 → CFW100-MMF) of
the inverter parameter table.
Indicates that there was an error
in the download
(CFW100-MMF → CFW100) of
the inverter parameter table.
Indicates that the charge of the
three AAA batteries (3 x 1.5 V) is
below 3.4 V.
Indicates an error occurred in
copy (CFW100 → CFW100-MMF)
of the inverter parameter table.
Indicates an error occurred in the
copy (CFW100 → CFW100-MMF)
of the inverter SoftPLC application.
Flash Memory Module
Description
CFW100 | 7