Content Of The Package; Installation And Configuration Of The Accessory - WEG CFW100 Installation And Operation Manual

Flash Memory Module
ATTENTION!
The CFW100-MMF Flash memory can
„
only remain connected to the CFW100
frequency inverter during the data transfer
operations.
Under normal operation of the inverter,
„
th e CF W10 0 - M M F m u st a l ways b e
disconnected.

3 CONTENT OF THE PACKAGE

Upon receiving the product, check if the package contains:
Accessory in anti-static package.
„
3 m mini USB cable.
„
Installation, configuration and operation guide.
„
4 INSTALLATION AND CONFIGURATION
OF THE ACCESSORY
The CFW100-MMF is easily connected to the CFW100
frequency inverter by means of the plug-and-play
concept. The procedures below must be observed for
the proper installation and start-up:
1. Disconnect the general power supply from the
CFW100 frequency inverter and remove the front
cover as per
2. Open the accessory as shown in
21.
3. Insert three AAA batteries.
4. Connect the cable to the CF W100-MMF and
CFW100 as indicated in
5. Energize the CFW100-MMF by means of the switch
shown in Figure A.3 on page
6. Using the COPY (CFW100 → CFW100-MMF) or
PASTE (CFW100-MMF → CFW100) keys, select the
direction of data transfer (inverter parameter table).
7. Press the OK key to start the transfer. This data
transfer can take up to 30 seconds, depending on
the quantity of transferred data.
8. Wait for the "rdy" indication in order to finish the data
transfer (parameter table + SoftPLC application).
9. If you use the incorrect transfer direction key, return
to the Ready mode by pressing the ESC key.
6 | CFW100
Figure A.1 on page
Figure A.1 on page
20.
Figure A.2 on page
21.
20.