Television Control Panel; Power, Str, F, - / \/, + / /\, Tv/Av - Panasonic TX-76PW150A Operating Instructions Manual

Television Control Panel Buttons
Open the front panel door to gain access to the Television Controls, push the door at the point marked
with a triangle
Push again to close
PRE. TV/AV
BUTTON
PRE.
TV/AV
-
.
+.
\/
/\
Note:
When the television is in Stand-By it is possible to turn it back on by pressing the Programme Number UP
or DOWN button.
- + \/
WHAT IT DOES
POWER
This button is used to turn the television on and off. The Indicator light (red)
will be on whenever the television is in Stand-By. The light will go out when
the television is running or turned OFF using the power button.
PRE. (Preset)
The button is used to select various functions. Push the button to select the
following functions sequentially:
SYS Select See page 21
Auto Tune See page 22
Manual Tune See page 23
POS. Setup See page 27
Geomagnetic See page 24
TV / AV
Pressing the TV/AV button will cycle between TV, AV1, AV2, AV3, AV4,
RGB and back to TV. If the RGB Skip is turned on then RGB will not be
selected. Please refer to page 17.
-
This button is used to decrease the volume. It is also used with the PRE.
button to select, change or adjust function settings.
+
This button is used to increase the volume. It is also used with the PRE.
button to select, change or adjust function settings.
\/
This button is used to select the next lower programme number.
/\
This button is used to select the next higher programme number.
RGB (31.5kHz)
AUDIO
L/MONO R
S-VIDEO VIDEO
PRE. TV/AV
AV2 IN
/\
7