Table of Contents
Advertisement
Remote Control VCR/LD/DVD Operation
Manufacturers' Code Settings
This remote control has been designed to work with a variety of VCRs, Laser Discs and DVD players. In
order for this to occur, the setting for the VCR, LD or DVD must be programmed into the Remote Control.
1.
To set a VCR, press the VCR button.
To set a LD or DVD, press the LD/DVD button.
2.
Push the remote control VCR - LD/DVD Power button and keep it Pushed.
3.
Enter the Manufacturer's two-digit code number using the remote control Number buttons (The
codes are shown below).
4.
Push the STOP button.
5.
Release the remote control VCR or LD/DVD Power button.
6.
Check the operation of the VCR, LD or DVD. If it does not operate correctly, repeat steps 1 to 5
and use an alternate code (if there is one).
VCR CODES
Manufacturer
Panasonic /
National
AIWA
FUJITSU
HITACHI
JVC
MITSUBISHI
LD CODES
Manufacturer
Panasonic
KENWOOD
PHILIPS
PIONEER
DVD CODES
Manufacturer
Panasonic
NOTES:
1.
If the batteries are removed from the remote control the Manufacturer's codes are lost and must
be reprogrammed.
2.
The list of manufacturer's codes is given as a guideline only. Panasonic cannot guarantee that
any other manufacturer's product will work with this remote control.
Please refer to drawing on pages 8 and 9 for location of VCR Control buttons.
32
Code
10, 11, 12, 13
15, 16
20
25, 26, 27
30, 31, 32
35, 36
Code
10, 11, 12, 13
15, 16
20
25
Code
70
Manufacturer
NEC
ORION
Philips
SANYO
SHARP
SONY
TOSHIBA
Manufacturer
SAMSUNG
SHARP
SONY
Code
40, 41, 42, 43
45, 46
50
55, 56, 57, 58
60, 61
65, 66, 67
70, 71
Code
30
35
40, 41, 42, 43
- Quick Links:
- Rgb Input
- Specifications
Hide quick links:
Advertisement
Table of Contents
