Getting Started
Battery Installation and Replacement
Place your thumb on triangle on the battery cover. Apply a slight downward pressure with the thumb and
slide the cover back. This allows the cover to be removed.
Insert the batteries ensuring the correct polarity. The polarity is identified by the " + " and " – " symbols on
the battery and the " + " and "– " symbols on the battery compartment. The springs inside the battery
compartment connect to the negative terminal of the battery.
Fit the battery cover and slide it forward until it "clicks" into place.
Battery Precautions
*
Do Not use rechargeable batteries. Differences in size and performance may cause
incorrect operation.
*
Do Not mix battery types (Alkaline with zinc-carbon etc.)
*
Do Not mix old and new batteries. Replace both batteries at the same time.
*
Do Not attempt to recharge batteries.
*
Do Not short circuit batteries.
*
Do Not disassemble batteries.
*
Do Not heat or burn batteries.
Caring for the Remote Control
The lens of the Remote Control should be kept clean and free of dirt and grease. Use a soft cloth
moistened with water and a mild detergent to keep the lens clean.
6
Lens
Two "AA" size batteries
Remote Control