Before Installing The Dms2.5 - Samsung MIM–B18BN User & Installation Manual

Before Installing the DMS2.5

Checks before installation
1 DMS2.5 IP
Basically, only Private IP can be set to IP address. To use Public IP, you must
set Enable public IP as 'Enable' from the menu [System Settings]
environment setting].
- Private IP range : 10.0.0.0 ~ 10.255.255.255, 172.16.0.0 ~ 172.31.255.255,
192.168.0.0 ~ 192.168.255.255
- Public IP range: IP except for Private IP range and 127.0.0.1(localhost)
DMS2.5 supports DHCP. If Public IP must be assigned from DHCP, you must
set Enable public IP as 'Enable' from the menu [System Settings]
environment setting].
DHCP(Dynamic Host Configuration Protocol)
An Internet protocol for automating the configuration of computers that use TCP/IP.
DHCP is used to automatically assign IP addresses.
In other words, the IP address of the host is supported only when the PC is on.
2 Network related equipments
DHCP(Dynamic Host Configuration Protocol)
An Internet protocol for automating the configuration of computers that use TCP/IP.
DHCP is used to automatically assign IP addresses.
In other words, the IP address of the host is supported only when the PC is on.
3 Installation connection wire
The LAN cable and the communication cables from OnOff controller/
modules must be installed in such a way that the wires can be connected to the
DMS2.5 with ease.
Note DMS2.5 supports Static IP or Dynamic IP. Web browser or S-NET series accesses
DMS2.5 using its IP address. If the web browser or S-NET series which accesses to
DMS2.5 are installed in a PC and the PC's IP is set to Public IP, you must register
the Public IP to DMS2.5 to access.
A static IP from an internet service provider must be used if xDSL (ADSL, VDSL) is
supported.
Use this product only in a separate dedicated network. Samsung electronics is not
liable for any problems caused by connecting it to the Internet or an intranet.
[System
[System
i nterface
5
E-