Dometic CK36H401RI Installation Manual page 14

Installation
I
NOTE
For the thicker roof seal refer to the instructions included with the
seal kit.
➤ Clip the transition duct (3) in place over the duct insert (1).
I
NOTE
Ensure the transition duct or seal is located correctly over the duct
insert, otherwise the performance of the unit may be affected.
➤ Raise the ceiling plate (5) into position and clip the transition duct into
place.
➤ The 4 bolts (4) are used to clamp the rooftop unit and ceiling plate into
place. Use the supplied washers with the bolts.
A
NOTICE! Risk of damage
 Tighten to the specified torque.
 Ensure all 4 bolts are tightened by the same amount. Uneven
tightening can cause distortion of the roof air conditioner and
result in possible damage.
➤ Tighten the bolts using a torque spanner and a fastening torque of
4.0 Nm.
Electrical connection
The complete circuit diagram can be found in fig. e.
See fig. b
240 Vw cable
➤ Connect the roof air conditioner with the 240 Vw voltage supply.
Connect the cables (1) to a cable connector (2).
Connecting the circuit board
➤ Connect to the ADB ceiling plate:
– the white 13-pin connector from the ADB cover (3)
– the black 4-pin connector from the rooftop unit (4)
14
Dometic Harrier Inverter
EN