Roof top unit used with 3105007.xxx or 3105935.xxx return air grille, electronic control kit, thermostat, optional indoor temperature sensor, air conditioner, ccc 2/lcd sz controls (17 pages)
Summary of Contents for Dometic Type 3241CX51R(CALR241)
Page 1
W/Electric Heat Heat Pump B3200 3311669.018CY1 3242CX51R Supplied by Dometic Note: Air Distribution Box installation requires a #2 Phillips screwdriver Australia contact with a 7 mm maximum diameter x 35 mm minimum length. www.dometic.com.au This manual must be read and...
SAFETY INSTRUCTIONS GENERAL INFORMATION Product features or specifications as described or il- lustrated are subject to change without notice. This manual has safety information and instruc- This Air Conditioner/Heat Pump (hereinafter referred tions to help users eliminate or reduce the risk to as the "unit"...
4. DO NOT add any devices or accessories to this 102 mm unit except those specifically authorized in writing Dimensions Are Nominal by Dometic Mobicool. 5. This equipment must be serviced by qualified personnel and some localities require these people to be licensed.
Page 4
b. The roof must be designed to support 65 C. Roof Preparation Kg. when the Vehicle is in motion. Normally 1. Opening requirements - Before preparing the ceil- a 100 Kg. static load design will meet this ing opening, read all of the following instructions requirement.
Page 5
E. Placing Unit On The Roof FIG. 5 This unit weighs approximately 45 Kilograms. To prevent back injury, use a mechanical hoist Do Not Cut Good-Rafters Optional Metal to place unit on roof. Roof Structure Supported By Frame Or Rafters Cross Beams 1.
Page 6
5. EVENLY TIGHTEN MOUNTING BOLTS TO A 3. Base Pan Duct Adapter TORQUE OF 4.5 TO 5.6 NM (Newton Meters). a. Remove the liner from the foam tape and posi- This will compress the roof gasket to approxi- tion on the base so screw hole and air openings mately 13 mm.
Page 7
FIG. 13 Route the previously run 220-240 VAC power supply wire through the strain relief into the junction box. Tighten connector making sure not to damage wire. Remove the rear panel of the digital display(2 screws) plug the communication cable into the display and replace the rear panel.
FUNCTION DISPLAY Digital display. Displays set temperature. (Flash when receiving a command) Power Status, (Green when Auto Button. power is on. Stand by mode.) FIG. 14 , (Yellow Timer Status when timer is set) Heating Status , (Orange when in heating mode) Cooling Status, (Blue when in cooling mode) Auto button.
OPERATING INSTRUCTIONS Cold mode Press MODE button to select cold mode then set the A.Remote control expected temperature between 18°C and 30°C. Selecting functional status Press the fan speed button to select low, medium or high FIG. 15 fan speed or automatic speed. Auto speed Low fan speed Dehumidification mode...
FAULT CODE & FUNCTION DESCRIPTIONS Fault condition Note Digital display code Room temperature sensor fault Call for service Evaporator sensor fault Call for service communication fault Call for service Condenser sensor fault Call for service Defrosting instructions Indicates defrosting in progress 1.
Page 12
ROOF MOUNT ASSEMBLY Rear Discharge Duct Roof Opening Mounting Bolts Duct Adapter Ceiling Template With Metal Brackets Vents Filter(s) Air Distribution Box (ADB)
2. Air distribution box model and serial number found on rating plate located on ceiling template. Observe this rating plate through the air distribution box right side vent opening. Dometic Australia Pty Ltd ABN 620 086 366 305 PO Box 1140 Clayton South...