2.18.4
Notes
•
The selection of the measured quantity depends on the
selected input voltage and current connections.
•
If the number selected is too large, "Overflow" is displayed
and the input value is automatically set to the maximum value.
•
If the power supply voltage is switched off during
programming, the message illustrated below appears when
the device is restarted. Therefore, the power supply voltage
should only be switched off in level 1 (measuring screens).
Note:
This means, that you should always leave the parameter
screens completely (OK or Cancel) until the measurement
screens are displayed again. This ensures that all parameters
will be accepted by the device.
Note:
Please check the parameters and the adjustment data
afterwards, to ensure the correct function of the SIMEAS P.
If you have adjusted the device manually, these data will not
be overwritten by default settings.
97