Related Manuals for J-Power KATANA
Summary of Contents for J-Power KATANA
- Page 1 Assembly and Operating Manual KATANA Specification: *Length: 27‐1/5"(690 mm) *Wing span: 23‐3/5"(600 mm) *Flying weight: 12‐7/10 oz (360g) ...
- Page 2 Assembly and Operating Manual KATANA Dear customer, To fly the KANATA you will need a radio control cure (harden) to the point where the joint can be system with at least four channels. 2.4GHz radios placed under stress. Congratulations on your choice of a...
- Page 3 Assembly and Operating Manual KATANA Fig. 1 -Apply glue to wing set. Fig. 2 -Install wing set on fuselage, photo shows the finished view . Fig. 3 - Glue horizon tail to fuselage. Fig. 4 -Photo shows the finished view.
- Page 4 Assembly and Operating Manual KATANA Fig. 5 - Glue vertical tail to fuselage. Fig. 6 - Photo shows the finished view . Fig. 7 -Locked control horns with screws. Fig. 8 -Connect the electronic speed controller and servos to the receiver. Refer to the radio instructions for the...
- Page 5 Assembly and Operating Manual KATANA Fig. 9 - Locate the battery and canopy. Charge the battery according to the safety instructions before installing. Fig.10 -Turn on the transmitter ,Put the throttle to the lowest position .connect battery and ESC Fig. 11-12 Checking Ailerons - Check that the control surfaces respond to the appropriate movements of the transmitter sticks.
- Page 6 Assembly and Operating Manual KATANA Fig. 13-14 Checking Elevators -Move the elevator stick down, and the elevator(a) must rise up, Move the elevator stick up ,the elevator (b) fall down. Fig. 15-16 Checking Rudder -Move the rudder stick to the left (a), and the rudder direction (a) must left, Move the rudder stick to the right(b), and the rudder direction (b) must right.
- Page 7 Assembly and Operating Manual KATANA Fig. 17 Checking the power system -Hold the model securely. -Remove any loose objects such as cloths, tools,etc from the area in front of the model, as they could easily be sucked into the ducted fan.
- Page 8 Assembly and Operating Manual KATANA Fig. 19 Checking the models balance -Place the flight battery in its compartment, without connecting. -Mark the Centre of Gravity (CG) on both sides of the fuselage; the position is shown in the photo. -Support the model at the marked points and allow it to hang freely.
- Page 9 Assembly and Operating Manual KATANA - With the motor running at full-throttle, give the - Switch the transmitter on, and connect the aeroplane a firm launch directly into any breeze, Test-flying, flying notes flight pack with the fuselage and wings level.
- Page 10 J-POWER GROUP CO.,LTD 5th Floor, A3 Building, Xinjianxing Technology Industrial Park, Fengxin Road, Guangming Town, Bao'an, Shenzhen City, 518107 China Phone: +86 755 33699201 Fax: +86 755 33699203 www.jpower.hk...