Step 1 Loading Ms-Dos; Step 2 Loading The Diagnostic Test Program - Toshiba T1100 PLUS User Manual

DIAGNOSTICS/Chapter
3·
If you suspect a memory problem, run the Diagnostics Test
program.
If
problems persist, consult your dealer.
The steps listed below take you through the Diagnostics Test program.
Before you begin the Diagnostics Test, remember that should any
errors occur during the running of the test, check first to make sure the
following are in order:
D
All cables are properly connected
D
All switches are properly set
o
The battery has enough power
The steps below assume drive A, the upper drive, is the current drive
and drive B, the lower drive, is the alternate drive.
Step 1. Loading MS-DOS
Begin the Diagnostics test program by loading MS-DOS into the com­
puter. See Chapter
on how to load MS-DOS.
Step 2. Loading the Diagnostic Test Program
At the system prompt, type the word
Diagnostics Test program.
program is loaded into the computer and the diagnostics menu appears
on the screen.
If the diagnostics menu does not appear on the screen, the MS-DOS
system disk is faulty.
diagnostics menu still does not appear, have the computer serviced.
9/14
9
5,
'Operating the TIIOO PLUS,' for instructions
TEST.
Enter.
Press
Try another MS-DOS system disk.
This is the name of the
The Diagnostics Test
If the
-