Preface - Texas Instruments 880 User Manual

This manual describes the installation, operation,
limited maintenance, and software control of the
Texas Instruments OMNI 800* Model 880 and
Model 880 DP Printers. All references in this
manual to the Model 880 Printer include the Model
880
DP Printer, unless otherwise specified.
Section
1,
INTRODUCTION - Provides a short
summary of the Model 880 Printer features, and
shows sample printouts.
Section 2, INSTALLATION - Describes how to
install and prepare the printer for operation.
Section
3,
CONTROL PANEL OPERATION
Describes how to use the operator panel to select
printer features and printer configuration.
Section
4,
PROBLEM ANALYSIS - Describes the
Test mode, status report, defines diagnostic error
codes, and outlines troubleshooting procedures.
Section
5,
SOFTWARE COMMANDS
Describes software control of the printer, including
control characters and escape sequences.
Section 6, RASTER GRAPHICS - Describes
. escape sequences and control characters for hori-
zontal and vertical raster graphics.
Section 7, COMMUNICATION INTERFACES
Describes serial and parallel communication inter-
faces.
*
Trademark of Texas Instruments Incorporated.
Preface
The appendixes discuss:
A - TI Business Systems
B - Maintenance
C - Control and Character Codes
D - Power Requirements and Grounding
E - Options and Accessories
F - Specifications
Other Documents
The document below provides additional infor-
mation forthe Model 880 Printer:
Mode/BBO Printer Maintenance Manua/
(TI Part No. 2222628-0001)
To receive a copy, send a request (purchase order)
to:
Texas Instruments Incorporated
Terminal Spare Parts - MIS 7793
P.O. Box 1444
Houston, Texas 77251
iii