Loading The Paper - Texas Instruments 880 User Manual

6. Set the full spool on the right hub. Rotate
the hubs to pull the ribbon tight.
7. Returnthe printhead adjustment lever to
its original position (step 3), or follow the
"ADJUSTING THE PRINTHEAD" proce-
dure in subsection 2.8.
2.5 LOADING THE PAPER
The Model 880 Printer has a bottom and rear
paper path (see Figure 2-8). Either path can be
used for single-thickness forms. The bottom path
is recommended for multiple-thickness forms. To
PAPER OUT
SWITCH
BOTTOM PATH
load paper, refer to Figures 2-8 and 2-9 and com-
plete the following steps.
1. Open the printhead door.
2. The left tractor must be to the left of the
paper-out switch (Figure 2-8). If it is not,
loosen the locking lever (Figure 2-9) and
slide the left tractor to the left so that
when the paper is installed, the paper will
cover the paper-out switch. Tighten the
lock lever.
3. Open the covers on both tractors.
TRACTORS
2222627-11
Figure 2-8. Loading the Paper
~=-=-==~-----
-------==---
Figure 2-9. Left and Right Tractors
RIGHT LOCKING LEVER
-ROTATED FORWARD
(MOVABLE)
2222627-12
2-5