Configuration Codes; 3.3.2.2 Changing Configuration Codes - Texas Instruments 880 User Manual

Follow these steps to print the configl.lration report:
1. Open the printhead door.
2. Press the Command key. The Normal
indicator turns off and the Command indi-
cator turns on.
3. Press the Menu key. The Menu indicator
turns on. The printer immediately prints a
form report.
4. Press the Accept key. The printer immedi-
ately prints a configuration report. The fol-
lowing example shows a typical
configuration report.
CNFG: 14; 27; 36; 41; 81; 9B
3.3.2.1 Configuration Codes. The numbers
listed in the configuration report are codes for the
various configuration features. Configuration
codes are listed in Tables 3-1 and 3-2. The
numbers in the configuration report are for the fol-
lowing configuration features.
• 1st code: Communication mode
• 2nd code: Baud rate
• 3rd code: Parity
•
•
4th code: National language version
Sth code: Miscellaneous features (More
than one of these can be
selected.)
3.3.2.2 Changing Configuration Codes.
Follow this procedure to print the configuration
menu and make new configuration selections:
1. After printing a configuration report as
described in paragraph 3.3.2,
"Configuration Report and Menu,"
press the Change key. The printer
begins to list the configuration menu by
printing the currently selected code for
communication mode, as shown below.
COMM MODE
=
14-0N
ON means the feature is selected (ac-
tive). OFF means the feature is not
selected (inactive).
2. Press the Change key. The printer turns
off code 14 and shows the next com-
munication mode code, which in this
case is 1S. (The codes appear in numeri-
cal order.)
COMM MODE
=
14-0N 14-0FF 1S-0N
3. Press the Accept key to select configu-
ration code 1S. (Or, you can keep press-
ing the Change key, and the other
configuration code choices will be listed
until you press the Accept key to select
one.) The printer now underlines your
choice for communication mode and
lists the currently selected baud rate
code, as shown below.
COMM MODE
=
14-0N 14-0FF 1S-0N
BAUD RATE
=
27-0N
4. Press the Change key. The printer turns
off code 27 and shows the next choice
for baud rate, which is 28, as shown in
the following example.
COMM MODE
=
14-0N 14-0FF 1S-0N
BAUD RATE
=
27-0N 27-0FF 28-0N
3-9