Hardware Installation; Using The Rocketraid 600L Series Hba - HighPoint RocketRAID 600L Series Quick Installation Manual

Connector and Jumper description
Connector
A1
F1
J1
Beep 1
Port
Connector
Active/FAIL LED PIN connector:
A 1-Pin connection from the HBA to an LED on the chassis. For detailed
LED connection requirements and display information, please refer to the
FAQ:
http://www.highpoint-
tech.com/websupport/kb_view_article_noauth.php?id=32

Hardware Installation

Installing the RocketRAID 600L Series HBA
Note: Make sure the system is powered-off before installing the
RocketRAID 600L Series HBA.
1. Open the system chassis and locate an unused PCI-E (2.0/1.0) (x4,
x8, x16) slot or (3.0) (x16) slot.
2. Remove the PCI slot cover.
3. Gently insert the RocketRAID 600L HBA into the PCI-E slot, and
secure the bracket to the system chassis.
4. After installing the adapter, attach the hard disks or disk enclosure to
the RocketRAID 600L HBA using the appropriate cables (SATA or Mini-
SAS).
5. Close and secure the system chassis.
RocketRAID
640L
Active LED PIN
Fail LED PIN
I2C Connector
SATA
RocketRAID
642L
Alarm Buzzer
SATA and
eSATA
5
RocketRAID
644L
N/A
N/A
N/A
eSATA
RocketRAID
644LS
Mini-SAS