Table of Contents
Advertisement
Use and Maintenance Manual
Residential Vacuum Units
Motor Failure *** Press Reset and contact Service Center ***
The control unit indicates that there is a fault in the engine. In the presence of this failure, the control unit
is not able to function.To reset the operation of the control unit, it is necessary to intervene and call a
Service Centre, by calling the free number indicated on the nameplate of the unit.
5.7 Programming the user interface
5.7.1. General Information
The user interface supplied with models Intelligence and Total is already programmed for the requirements
of normal use. If necessary, the preset parameters can be modified to cater for individual needs.
Programmamble Parameters
FILTER CARTRIDGE CLEANING
(Models W1000 end i1000)
FILTER CARTRIDGE CLEANING
(Models W1250, i1250, i1600 end i1750)
DUST CONTAINER EMPTYING 8 lt
(Models W1000 end i1000)
DUST CONTAINER EMPTYNG 18 lt
(Models W1250, i1250, i1600, i1750, T1250, T1600 end T1750)
SELF-CLEANING
(Models T1250, T1600 end T1750)
CONTINUOS OPERATION
(entire range)
5.7.2. Personalization of maintenance parameters
With the procedures described here, users can modify the preset maintenance parameters or the
personalized values programmed previously, with a series of simple operations on the user interface.
Filter Cleaning:
Enter the USER MENU by pressing the SET button when the display shows the STANDBY message. Scroll
through the USER MENU with the UP and DOWN keys until you reach the FILTER CLEANING submenu. Press
the SET button again and then use the UP and DOWN keys to enter the desired value. To memorize the
new value entered, keep the SET button pressed down for a few seconds until the MEMORIZED message
appears.
To leave this display press the RESET button.
Dust container emptying:
This procedure is used to modify the parameter that controls alarm operation, set by default at 5 hours on
models W1000 and i1000, and at 10 hours for models W1250, i1250, i1600, i1750, T1250, T1600 and
T1250. Enter the USER MENU by pressing the SET button when the display shows the STANDBY message.
Hours of operation
Minimun
hours
1
hours
1
hours
1
hours
1
Min.
30
Min.
30
>>> Use of main vacuum unit
Preset
Maximum
10
20
20
40
5
20
10
40
45
240
45
600
28
Advertisement
Table of Contents
