Table of Contents
Advertisement
Use and Maintenance Manual
Residential Vacuum Units
4.4 Reversibility of suction and outlet connections
Main vacuum units are normally supplied with connections for air inlet and outlet pipes on the right. If
necessary, this direction can be modified by independently moving the air inlet and outlet connections to
the left.
ATTENTION:
Before carrying out this operation, it is compulsory to unplug the unit from the
230 V power supply wall socket.
To reverse the suction connector, proceed as follows:
1. Unscrew the screws and remove the reversible support/inlet. (figure 13)
2. Rotate the reversible support/inlet through 180°. (Figure 13)
3. Replace the reversible support/inlet in the new position (Figure 14)
Figure 13
To reverse the outlet connector, proceed as follows:
Mod. 1000-1250:
Remove the screws and reverse due Covers Side (with and without the expulsion)
Mod. 1600-1750:
Remove the grid on the stadium spacer and with a pliers remove the expulsion cap.
Place them in the same order on the opposite side of the expulsion.
>>> Residential Vacuum Units Installation
Figure 15
Figure 14
22
Advertisement
Table of Contents
