Soaking - Bosch WFT2806GB Instruction Manual And Installation Instructions

Special programmes

Soaking

1. Only put items of the same colour into the
drum.
2. Put detergent for soaking in chamber I.
Follow the manufacturer's instructions on
the package.
Note: If the soaking suds are to be retai
ned for the main wash programme, a de
tergent suitable for drum type washers
must be used. (Risk of excessive foam
formation!)
3. Set programme selector to Easy-care 30
or 40.
4. Press the "Pre Wash" and "Higher Water
Level" buttons.
5. Press the "Start" button.
6. After approx. 15 minutes, set the pro
gramme selector to X and wait until the
"End" control light illuminates or flashes.
Now set programme selector to
allow laundry to soak in suds as long as
desired.
Note: After one minute the loading door is
!
unlocked. Suds may exit upon opening!
To end the soaking programme:
– Select spin programme suitable for your
fabric. To avoid heavy foaming choose a
wash programme with prewash after the
spin cycle but do not put any detergent
into compartment I.
– If the laundry is to be washed in the soak
ing water: Press the prewash button to
return it to its original position; set the pro
gramme selector to the desired pro
gramme and start it without adding further
detergent.
Starting a wash programme automatically
after soaking
You can utilise the delayed start time function
to effect the automatic termination of the
soaking cycle.
7. Dependent upon the fabrics being was
hed, choose a wash programme with pre
wash, but do not fill any detergent into
chamber I of the soap dispenser.
8. Use the "Start in Hours" button to set the
desired soak time.
Starching
Do not use fabric conditioner before starch
ing
1. Dissolve starching agent in water.
Follow the manufacturer's instructions on
the package.
2. Set programme selector to 8.
3. Press the "Start" button.
The "Final Rinse" control light illuminates
in the programme sequence display.
4. When the water runs in, pull the soap dis
penser out slightly and pour starching
agent in chamber II.
5. Close soap dispenser.
The starching programme takes approx.
25 minutes and ends with a short, gentle spin
at 800 r.p.m.
If the laundry is to be removed dripping wet,
press the "Rinse Hold" button prior to starting
the starching programme.
and
If the laundry is to be dried in the washer/dryer
subsequent to the starching cycle, add approx.
30 to 50 % more starch, and select the "Extra
spin" programme with the maximum spin
speed to attain the highest degree of water ex
traction.
Fluff removal (after the drying pro-
gramme)
Garments fluff as a result of ordinary wear
and this fluff comes off during the drying pro
cess, some of which may remain in the
machine. Please remove any fluff deposited
on the rubber gasket. Normally, fluff which
may be in the machine is washed away dur
ing the next wash. However, we recommend
that you run a self cleaning programme after
every drying programme as follows:
6. Remove the laundry, but do not add de
tergent.
7. Turn the programme selector to 7.
8. Press Start" button.
The machine will do a rinse cycle and
then a spin cycle thereby removing any
fluff deposited in the machine.
23