Bosch WFT2806GB Instruction Manual And Installation Instructions page 31

Rectifying minor malfunctions yourself
If a control light is flashing in the programme sequence indicator on the operating panel, or a
light is illuminated and a number appears in the Start in Hours / Ready in Min." display, this is
an indication of either a deviation from the normal programme sequence or an operational mal
function.
If you notice one of the displays listed in the following, you can rectify the malfunction yourself.
Control lights in the programme
sequence display
Pre Wash
Pre Wash
Washing
If all details have been checked, set the programme selector to the
and proceed by again selecting and starting the initially selected programme. If the control
lights again flash or illuminate, this indicates an operating malfunction which requires customer
service.
Customer service must also be notified when the following displays are noted:
Control lights in the programme
sequence display
Rinsing
Final Rinse
Display
Number in the
Start time dis
play
Drying
Anti Crease
Anti Crease
Display
Number in the
Start time dis
play
Drying
Drying
P Possible causes /
Remedial action
– Porthole not closed.
15 Close porthole - programme starts
immediately
– Water tap not open.
Open water tap - programme
starts immediately.
3
– Blocked inlet filters in water
supply. For cleaning filters, see
page .
– Blocked drain hose, drain pipe or
suds pump.
1
For cleaning the pump, see
page 27.
Possible causes
– Water in the bottom pan.
(Applies only to units featuring
2 Aqua Stop.)
The unit is leaking. Close the
water tap!
– Defective heater.
4
Switch unit off!
ibl /
position. Wait 5 seconds,
31