Starting The Programme; Soaking Laundry; Adding Laundry; Cancelling The Washing Programme - Bosch WNA14411GR User Manual And Installation Instructions

Table of Contents

Advertisement

14.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press Έναρξη/Προσθήκη
1.
ρούχων .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
If the display shows
2.
dry is not spun. The water is
pumped out after the rinse cycle.
Notes
¡ If you do not remove the laundry
once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes. The display shows 0:
00, ⁠   ⁠   ⁠ , ⁠   and End alternately,
and
appears.
Press any button on the display to
cancel the crease-reduction pro-
gramme and to remove the laun-
dry.
¡ If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
14.7 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Έναρξη/
Προσθήκη ρούχων .
To resume the programme, after
3.
the desired soaking time, press
Έναρξη/Προσθήκη ρούχων .
, the laun-
14.8 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Έναρξη/Προσθήκη
1.
ρούχων .
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Έναρξη/Προσθήκη
5.
ρούχων .
14.9 Cancelling the washing
programme
Press Έναρξη/Προσθήκη
1.
ρούχων .
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Ξέβγαλμα programme.
– If the water level is high, start
the Στύψιμο programme or se-
lect a suitable programme for
draining.
→ "Programmes", Page 26
Remove the laundry.
3.
→ "Unloading the laundry",
Page 32
Basic operation en
31

Advertisement

Table of Contents
loading

Table of Contents