Table of Contents
Advertisement
en Basic operation
14.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press
Start/ Reload.
1.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
If the display shows
2.
is not spun. The water is pumped
out after the rinse cycle.
Notes
¡ If you do not remove the laundry
once the programme has ended,
the crease-reduction function starts
after 15 minutes and takes approx.
30 minutes. The display shows 0：
00， ， and End alternately,
and
appears.
Press any button on the display to
cancel the crease-reduction pro-
gramme and to remove the laun-
dry.
¡ If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
14.9 Soaking laundry
Note: No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
Requirements
¡ The laundry is placed in the appli-
ance.
→ "Loading laundry", Page 30
¡ A programme has started.
→ "Starting the programme",
Page 32
32
, the laundry
Press
Start/ Reload approx.
1.
10 minutes after the programme
start.
The programme pauses and the
laundry can soak.
Press
Start/ Reload after the
2.
required soaking time.
14.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press
Start/ Reload.
1.
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
Start/ Reload.
5.
14.11 Cancelling the washing
programme
Press
Start/ Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 26
Remove the laundry.
3.
→ "Unloading the laundry",
Page 33
Advertisement
Table of Contents
