Replacing The Display Bezel; Procedure; Post-Requisites - Alienware 15 R3 Service Manual

Replacing the display bezel

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.

Procedure

1 Place the display assembly on a clean and flat surface.
2 Connect the tron-light cables to the logo board.
3 Connect the logo-board cable to the logo board.
4 Slide the alien head cable into the logo board and close the latch to secure
the cable.
5 Carefully turn the display bezel over.
6 Align the display bezel with the display back-cover and gently snap the
display bezel into place.

Post-requisites

1 Replace the
2 Follow the procedure from step 2 to step 16 in
3 Replace the
4 Replace the battery.
5 Replace the
6 Replace the
7 Replace the
8 Follow the procedure from step 4 to step 6 in
9 Replace the
10 Replace the
display assembly.
memory modules.
computer base.
rear-I/O cover.
solid-state drive.
wireless card.
base cover.
computer. After working inside your
After working inside your
"Replacing the hard
"Replacing the system
computer.
board".
drive".
91