What To Do If - Electrolux ESF 2200 DW User Manual

A
2. To remove the coarse filter (C), hold
tightly the fine filter (B) and press the
two sides of the coarse filter (C).
3. Pull the coarse filter (C) out of the fine fil-
ter (B).
C
B
4. Fully wash the two filters with water and
a brush.

WHAT TO DO IF...

The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
The indicator of the programme 'Rinse & Hold'
flashes very quickly.
An intermittent acoustic signal operates for ap-
proximately 30 seconds.
The indicator of the programme 'Delicate 45°'
flashes very quickly.
An intermittent acoustic signal operates for ap-
proximately 30 seconds.
Warning! Deactivate the appliance
before you do the checks.
B
5. Remove the main filter (A) and fully wash
it with water.
6. Put the main filter (A) in its initial posi-
tion. Make sure that it assembles cor-
rectly.
7. Put the fine coarse filter (C) in the fine fil-
ter (B). Make sure that they assemble
correctly in each other.
8. Put the fine filter (B) in the main filter (A)
and turn it clockwise until it locks.
Caution! Do not use the appliance
without the filters.
Make sure that the installation of the fil-
ters is correct. An incorrect position of
the filters will cause bad washing re-
sults and damage to the appliance.
TO CLEAN THE SPRAY ARM
Do not remove the spray arm.
If the holes in the spray arm become clog-
ged, remove remaining parts of soil with a
thin pointed object.
TO CLEAN THE EXTERNAL SURFACES
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (e.g. acetone).
With some malfunctions, alarm codes
show:
The appliance does not fill with water.
The anti-flood device is on.
electrolux 11