Kenwood TK-8102 Service Manual page 13

2. SmarTrunk
1. Unscrew the five M2.6 screws (N87-2614 -46), then re-
move the shielding cover (F10-2491-03).
M2.6 screws
2. The SmarTrunk Board is to be mounted in the silk-
screened area.
Silk-screen
3. Adhere one side of the 27 x 17.5 x 1mm cushion G (G13-
2005 -04) to the underside of the ST-909.
ST-909
(Top side) Back of ST-909
INSTALLATION
Shielding cover
Cushion G
4. Connect the cable (E37 -1117 -05) to the topside of the ST-
909.
Cable
5. Mount the ST-909 onto the TX-RX PCB using the adhesive
cushion on the underside of the ST-909, onto the left edge
of the silk-screen area. Connect the cables to the two ter-
minals.
ST-909 mounted at edge
Terminals of silk-screened area
6. Adhere the 13 x 9 x 8 mm cushion F (G13-2006-04) to the
top side of the ST-865KW4, between the variable resistor
(R18) and the capacitor (C19), then place the supplied in-
sulation sheet over the integrated circuit (IC).
Cushion F
Part No. : G13-2006-04
Variable
resistor
IC
TK-8102
Connect point ST-909
Capacitor
13