Malfunctions; Transport; Disposal - Taski swingo 1650 Translation Of The Original Instructions Of Use

Service intervals
TASKI scrubber dryer machines are built to the highest quality standards and
have been checked for safety in the factory and by authorised inspectors.
Electrical and mechanical parts are subject to wear or aging if used for long
periods of time.
• In order to ensure operational reliability and
availability for use, the service must be carried
out when the service indicatior lights up (factory
setting 550 working hours) or at least once a
year.
Shorter intervals are necessary in case of rough environments or special
conditions of use and/or inadequate maintenance.
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.
Cleaning or replacing the float (Overfilling protection for recovery tank)
• Switch the machine off using the keyswitch and remove the key.
Disassembly:
• The yellow suction filter can be simply removed
together with the float (quick-release
connection).
• Clean it with water using a brush (let it dry out
well).
• Brush the yellow suction filter with a soft brush
or remove the fluff with a cloth.

Malfunctions

Malfunction Possible causes
Machine does not
Maschine switched off
run
Battery/mains
Discharged batteries
unit malfunction
(display on Batteries/battery
control panel) charger defective
Power cord not
plugged in or
Batteries not defective
sufficiently
charged
Batteries or battery
charging unit
defective
Brush does not Motor runs but not
turn tool
The float closes the
inlet opening at the
suction unit (overfill
protection for
recovery tank)
Squeegee not on the
floor
Suction hose not
connected
Check the seal on the
tank lid for cracks/dirt
Poor vacuum
performance
Suction filter blocked
Floor remains
Hose or nozzle
wet
blocked (e.g. by
pieces of wood or
Soiled solution
residual material)
not picked up
The blades do not
adjust well to the floor
consistancy
Dirt sieve full (yellow)
Solution tank empty
Insufficient output
of cleaning
Solution tank filter
solution
blocked
Foam or liquid
leaking from the Float malfunction
machine

Transport

Transport the machine in an upright position and remove the batteries for
transportation where necessary.
Make sure that the machine is securely fastened within the transportation
vehicle.
Refer to page 28 for the dimensions and weights.

Disposal

When it has reached the end of its operational life, the machine and its
accessories must be disposed of according to the national regulations. Your
TASKI partner can support you with proper disposal upon notification.
Batteries
The batteries must be removed from the machine before being disposed of
properly.
Used batteries must be disposed of in an environmentally appropriate way in
accordance with the EU guidelines 2006/66/EEC.
Troubleshooting page
• Switch on the
keyswitch. 22
• Recharge batteries
22
• Call for technical
assistance
• Plug in the power cord
• Call your Service
Partner
• Call your Service
Partner
• Call for technical
assistance
• Check the recovery
25
tank is not full
• Check that the float is
27
functioning correctly.
• Lower the squeegee.
25
• Connect suction hose
24
• Clean the seal, or
replace if defective
• Remove the blockage
• Remove the blockage
• Clean the squeegee
• Change/turn the
blades
• Check that the
squeegee suspension
is functioning correctly
• Squeegee adjustment
• Remove the dirt sieve
• Empty the dirt sieve 26
and rinse it under
running water.
• Fill the solution tank 24
• Clean solution tank
26
filter
• Turn off the suction 22
aggregate
27
• Check that the float is
functioning correctly.
• Check the suitability of
the chemical product
for use with scrubber
dryer machines.
27